CNC lathe is common lathe CNC programming techniques are used on the basis of to make operation more convenient to use. CNC lathe used in environmental requirements, power requirements, temperature conditions, and standards are provided.
CNC lathe equipment must meet the following conditions of normal use, small machine tool the location of supply voltage fluctuation, ambient temperatures below 30 degrees as shown in degrees, relative humidity is less than 80%.
1, environmental requirements
The location should be away from the vibration of machine tool source, avoid direct sunlight and heat radiation effects, avoid the effects of moisture and air. Near asource of machine tools, you should set the vibration-proof trench around the machine. Otherwise, will directly affect the working accuracy and stability will make poor contact of electronic components, failure affecting the reliability of the machine.
2, power requirements
General CNC lathes installed in the machine shop, not only changes in ambient temperature, poor conditions of use, and a variety of mechanical and electrical equipment and power fluctuations. Therefore, the installation location of NC lathe, needs power supply voltage control. Fluctuations in supply voltage must be within theallowable range, and has remained relatively stable. Otherwise it will affect the system work properly.
3, temperature
CNC lathe temperature below 30 degrees as shown in degrees, relative humidity is less than 80%. In General, the CNC electrical control cabinet equipped with exhaust fan or air-conditioning to maintain electronic components, especially the CPU operating temperature or temperature difference is small. Too high a temperature andhumidity control system reduced life expectancy and cause failure increases. Increases in temperature and humidity, dust increases would have a bonding circuit board and cause a short circuit.
4, regulating the use of machine tools
When a user uses the tool, do not allow to change factory set parameters within the control system. The setting of these parameters directly related to the dynamic characteristics of machine tool components. Only clearance parameter values maybe adjusted according to the actual situation.
Users cannot free replacement machine tool accessories, such as hydraulic Chuck is used beyond the specification. Factory setting attachment, fully taking into account the parameters match. Blind caused by replacing the parameters do not match,even cause accidents cannot be estimated.
Use hydraulic chucks, hydraulic head, hydraulic tailstock and hydraulic cylinder pressure shall, within the scope of permissible stress, do not allow any increase.
