五月天高清无码一区_亚洲一二三中文字幕视频_国产人妖网站大全免费在线观看_久久人精品无码午夜福利_日欧二区三区影院_超碰caoporen国产精品_欧美极品在线观看蜜桃视频_韩国丰满少妇A级毛片_777kkk亚洲综合欧美色老头_99人妻在线超碰

utomatic grinding machine maintenance procedures

1. When you are using circulating water tank supply, processed each day, replace the water processing to avoid pipe blockage caused by dirt in the tank.

2. when changing the water, please unplug the power plug, remove the water tank,pour off water and powder fouling and cleaning the water tank and filter the Internet.

3. processing resin film, creates high foam in the tank. When changing the processing water, add defoamer, 7~10 injection times.

Antifoaming agents eliminate plastic foam. When the bubbles more time, can be targeted directly to Bubble Jet 2~3, stir after effects better.

4. clean the spout.

Spout once jams, less water or no water, resulting in reduced processing and evendoes not work. When you clean the spout, place the nozzle unplug, clean nozzle blockage with a fine needle.

5. clean Edger waterproof cover.

Working long hours, cutting dust will make lens attached to the waterproof cover, if it is not cleaned in time, cutting dust will be cured, and difficult to remove. Observation on the influence of line of sight. Processing after the end of each day, usingbrushes and spray water tank cleaning.

6. clean grinding Chamber.

Processing for a long time, will make the clamp shaft, Chuck and grinding Chamber attached to the cutting dust, if it is not cleared in a timely manner, will scratch glass, may also make the clamp shaft seal ring wear lead to head into the water. Cleaning method has the following two types:

(1) water container with brush and spray cleaning directly.

(2) enter the cleaning machine cleaning mode. This method while cleaning the inside of the machine the water supply pipe.

Concrete steps refer to the operating instructions.

7. clean Edger and scanner casing.

After using your machine every day must be clean. Then a few days later, cutting powder curing in the shell, it will be difficult to remove. Use a soft cloth and neutralcleaning agent to clean shells.

8. trim wheel.

When grinding blunt and takes longer. To restore wheel performance should be trimmed (about 1000 pieces of glass grinding).

Methods are as follows:

(1) direct repair

1) wet sand.

2) boot.

3) to scan frame, transmit data when you are finished, start the machine (do not clip the lens).

4) nose falling off.

5) wheel inertia, stone repair, repair 4~5 times.

(2) enter the dressing mode

1) to move through the menu.

2) select mode of dressing.

3) to start the machine.

4) wheel inertia, stone repair, overhaul.

5) start a wheel run for a few seconds, so you can trim 4~5.

9. the prop rod moves up and down head milling machine or on the support bar,add a little clock oil on a regular basis.