ylinder engraving machine is engraving machine engraving cylindrical material, often used in the manufacture of special trade and advertising, such as carved aluminum appearance and so on.
Cylinder engraving machine in the process of carving the phenomenon of dislocation is a regular thing, because there are a lot of problems, and involves a lot of parts, so it is a more difficult problem to solve. After many years of practical experience, Nanjing transit technology summed up the following for your reference:
Question 1, reasons for cylinder engraving machine drive: the drive itself inside thestructure or a problem with electronic components can cause dislocation of the phenomenon, for this reason most. If it does not occur frequently, and low speed, sometimes functioning as carving the drive isn't completely broken, if you start carving misplaced drive has been completely broken, this can be repaired or a bad drive.
Cylindrical engraving machine voltage 2, cause of the problem: the power neededto work, if the voltage is too low to drive a power shortage, power up to it will cause dislocation of the phenomenon, generally up to the y axis, this phenomenon can occur outside voltage is not enough, on the same line or someone using powerequipment such as welding, etc. Solution to this is to install a 50000-Watt power supply, but this error must not exceed the scope of the regulated power supply 5%,best 3%.
Question 3, cylindrical engraving machine interface board, Board, interposer board reasons: If the interface board, motherboard, adapter plate is broken, the machine in the process of working, in one direction or three axes are fixed, resulting in carving the dislocation.
Question 4, cylinder engraving machine spindle motor causes: reasons for steppermotors or servo motors, the entire machine is not moving in a certain direction, turn screw by hand won't turn.
Question 5, cylindrical engraving machine of the fuselage itself causes: some partson the machine have a question or loose surface impurities, such as dislocation can also occur. Such as loose coupling, is broken, there will be dislocation, Rails, time no refueling will also appear on the screw dislocation.
Issue 6, cylinder engraving machine engraving machine line broken if this behaviorwill also occur.
